Offices Nationwide
Reverberation Time
The reverberation time of a room is defined as the time it takes for sound to decay by 60 dB after an abrupt termination...more
Good Hearing?
A typical person with good hearing can hear from about 20Hz to 20kHz (the audio bandwidth). A person's voice will usually range from 500Hz to 2kHz...more
Thermal Bridging And Airtightness
Enhanced Construction Details
Information and guidance relating to thermal bridging for use with Enhanced Construction Details.
London - Part E Testing - 020 3390 0301
The counties covered by this office are:
Middlesex, Surrey, Hertfordshire, Berkshire, East Sussex, London, , Essex, Kent, Oxfordshire,
Phone Number: 020 3390 0301 Email: london@e2consultants.co.uk
Sound Insulation Testing for new or refurbished dwellings
In compliance with Part E of the Building Regulation in London and nationwide, we actively encourage clients to seek our services at the earliest opportunity.
It is possible that the noise mitigation measures required in some instances, could dictate significant changes to external and internal layouts. Therefore our early involvement could remove the need for costly revisions.
As part of our service in London we can also offer advice on the additional requirements of Approved Document Part E including the control of reverberation in common areas and the performance of internal walls and floors.
Our consultants at London can guide you through the process to ensure the best possible chance of achieving sound test passes.
E2 Consultants are specialists in the provision of high quality and practical acoustic consultancy to both the public and private sectors; typically working with residential and commercial developers, architects, planning consultants, industry, local planning authorities and environmental services.
Call 020 3390 0301 or email london@e2consultants.co.uk to get a quote from one of London consultants..
Pre-Completion Testing - The following table outlines the sets of tests required for new and converted properties:
| Property Types | Test Requirements |
Dwelling-houses Including bungalows |
Normally, one set of tests should comprise of two individual Sound Insulation Tests (SITs)(two airborne tests):1. Living room (wall) And 2.Bedroom (wall) |
Flats with separating floor but not walls |
Normally, one set of tests should comprise of four individual SITs (2 x airborn, 2 x impact): 1. Living room (Airborn), 2.Living room (Impact), 3. Bedroom (airborn) and 4. Bedroom (Impact) |
Flats with separating floor and walls |
Normally, one set of tests should comprise of six individual SITs (4 x airborne, 2 x impact): 1. living room/living room (floor, airborne), 2. living room/living room (floor, impact), 3. bedroom/bedroom (floor, airborne), 4. bedroom/bedroom (floor, impact), 5. living room/living room (wall, airborne) and 6. bedroom/bedroom (wall, airborne) |
Rooms for Residential Purposes |
To conduct a set of tests, the sound insulation between the main rooms should be measured according to the principals set out above for new buildings and material change of use, but adapting them to suit the circumstances. |
For further Part E Testing information for your area, be sure to check out Sound-Testing-East-London.co.uk.
Our other services include:
Part E Testing can also be known as:
Commercial Part E Sound Insulation Testing, Commercial Sound Testing Part E, Sound Testing Part E, Commercial Part E Testing, Part E Sound Testing, Commercial Part E, Part E, Commercial Part E Sound Testing, Sound Insulation Design Advice, Part E Sound Insulation Testing,
Copyright 2025 E2 Specialist Consultants Limited
Company No. 06728970